Configured camera with dip switches 9600 baud, camera #7, Pelco-P protocol (=1110100), 4-wire RS485 (=1000, tried 2-wire also = 1111), last camera in chain as I only connect 1 camera at a time. Other wires are for the alarm inputs and outputs (purple, green, red, black, yellow, blue, brown, orange, grey, white, pink, light green) The camera is a second user camera where the cable has been cut of, so I had to workout the wiring. I managed to get hold of the camera user and service manual, DVR manual, additional instructions re Pelco-P and RS485 from Panasonic I can see CCTV video fine, but am unable to control it with the DVR PTZ controls and it just runs a previous patrol scan Wonder if there someone out there with a similar setup or more experience than me with RS485.Ĭonnect the camera to the DVR via RS485.
0 Comments
Leave a Reply. |